Capital Fireplaces Oracle Raised Chamber Gas Fire from Fireworld

External Dimensions H xmm W xmm D xmm OutPut Note: No heat output figures are available from Capital Fireplaces the manufacturer, which would indicate that this appliance is suitable for decorative purposes only and should not be relied upon as a source of heat! Maximum heat input high 8.2Kw #

Details Designer Hole In The Wall Gas Fire Flue Suitable for class 1 chimney's or flue systems with a minimum internal diameter of 7" Ventilation Additional ventilation may be required #

Notes

Product		Width	Height	Depth
Akal		500	125	270
Boji		460	160	280
Oracle		500	125	255
Baskets
Sirocco		565	210	255

NOTE: Please ensure to have a survey carried out by a Gas Safe Register registered gas installer to check and certify the compatibility of your chimney or flue with this fire before making any purchase to avoid disappointment. For the chrome and bronze finishes please do not use an abrasice polish as this will remove the plating. # A heat input of 6.9kW or less do not normally require airvents, there are however some circumstances which overide this fact and mean vents shall be required, this is determined by your installer carrying out a spillage test.

A class 1 gather hood is available as an optional extra if you are connecting to a prefabricated flue or in instances where the product is being installed into an open chimney without a liner, which will also help to minimise heat loss and soot / debris falls onto the fire over time. Whilst fitting a gather hood is not considered to be a mandatory requirement (except when using a flexible flue liner or prefabricated flue), Capital Fireplaces recommend that a proprietary gather hood should be installed with each chamber installation. If you have opted to purchase any of the LB, Storm, Tempest, Hurricane or Tornado frames then you will require a sound structure in order to fix them to the wall (Please consult with your Gas Safe Register gas installer on this point). Due to the manufacturing process all dimensions shown are approximate and may vary slightly to allow for a tolerance of +/- 10mm. Also be sure to add 10mm to each individual dimension to establish the actual size of void required to install the raised chamber in the wall. Please note that whilst soot deposits on a gas fire are quite normal and to be expected, they will be more visible on a pebble, firewood or driftwood fuel effect. Similarly you may also experience discolouration when choosing the stainless steel chamber, which is the back panel behind the fire, which will vary in degree dependant on the flue pull and other local conditions, which again is quite normal and to be expected. *Although Capital Fireplaces display some of their products in photographs with and without a hearth the ultimate decision of whether a hearth is required or not is that of your Gas Safe Register registered gas installer, as Building regulations and Gas Safe Register regulations may differ in areas throughout the UK. However for the avoidance of doubt Capital Fireplaces would recommend that a hearth is installed.

For more detailed information about this product or to request a brochure visit www.capitalfireplaces.co.uk. If you would like to view this product before you purchase, please contact Capital Fireplaces directly who will be able to advise you on your nearest dealer.